Created on 04/18/2017
c
2017 Sun Hydraulics Corporation See www.sunhydraulics.com for detailed product information 1 of 2
MODEL
CXBM
Insert style, free flow nose to side check valve
CAPACITY: 40 L/min. / CAVITY: T-162DP
NOTE: DATA MAY VARY BY CONFIGURATION. SEE CONFIGURATION SECTION.
Free-flow, nose-to-side check valves are on/off circuit components that allow free flow from the inlet (port 1) to the
outlet (port 2) and block flow in the opposite direction.
TECHNICAL DATA
Cavity T-162DP
Series 0
Capacity 40 L/min.
Maximum Operating Pressure 350 bar
Maximum Valve Leakage at 110 SUS (24 cSt) 0,07 cc/min.
Valve Internal Hex Size 8 mm
Valve Installation Torque 27 - 33 Nm
Seal kit - Cartridge Buna: 990162007
Seal kit - Cartridge EPDM: 990162014
Seal kit - Cartridge Polyurethane: 990162002
Seal kit - Cartridge Viton: 990162006
Model Weight 0.03 kg.
(X)CONTROL
X Not Adjustable
(A)CRACKING PRESSURE
A 4 psi (0,3 bar)
B 15 psi (1 bar)
C 30 psi (2 bar)
(N)SEAL MATERIAL
N Buna-N
E EPDM
V Viton
snhy.com/
CXBM
TECHNICAL FEATURES
This valve is what we call an Insert style. It is meant to be buried in a manifold or actuator. The cavity drawing for the T-162DP cavity contains a lot of detailed
information and should be studied closely when applying this valve.
Model Code Example: CXBMXANCONFIGURATION OPTIONS
Created on 04/18/2017
c
2017 Sun Hydraulics Corporation See www.sunhydraulics.com for detailed product information 2 of 2
Two-port check valves share the same cavity for a given frame size, however, pay close attention as flow paths may be in opposite directions.
Check valves offer extremely low leakage rates with a maximum leakage of less than 1 drop per minute (0,07 cc/min).
Will accept 5000 psi (350 bar) at ports 1 and 2.
Cartridges configured with EPDM seals are for use in systems with phosphate ester fluids. Exposure to petroleum based fluids, greases and lubricants will damage
the seals.
Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge
machining variations.
PERFORMANCE CURVES
